VanCity Labs Hat Pin

Weed Hat Pin: Die-Cast VanCity Labs Logo

This weed hat pin is the VanCity Labs logo, die cast in zinc alloy and sized to sit on a snapback brim.

• Material: zinc alloy
• Size: 38 x 19 mm
• Thickness: 1.5 mm
• Back: sandblasted, single needle post
• Clutch: nickel butterfly

Die cast in zinc alloy at 38 x 19 mm, which is the size that sits properly on a snapback brim without hanging over the edge or disappearing into the stitching. At 1.5 mm the face is raised enough that the logo reads from across a room rather than blending into the fabric.

Single needle post on a sandblasted back, held by a nickel butterfly clutch. The butterfly is the one that actually stays put — rubber clutches walk loose and lose the pin off a jacket by the end of the night.

Where it goes

• The front panel or brim of a snapback
• A jacket lapel or denim collar
• A backpack or bag strap
• A lanyard or pin board

Push the post through the fabric, then press the butterfly clutch on from behind until it sits flat. To move it, squeeze the two wings of the clutch and it slides straight off.

Grab it with Lab Points or add it to your order

Every order earns Lab Points, and this is one of the things you can spend them on — redeem it from the Lab Points rewards catalogue or throw one in with your next order. See the rest of the gear in VanCity Labs Accessories.